Thursday, April 14, 2011

Shift Resistors and You

If you’re like me you often find yourself wondering what to do with the extra line cranks you have after flushing out your shift resistor. For many, the scenario is a very familiar one. You spend all weekend trying to get your shift resistor back in prime condition. You know there’s no need to buy a new one because just a little elbow grease and a lot of persistence can save you quite a bit of money. But at the end of the day you’re left with twice as many line cranks as you started out with and an overheated barrel jolt.

Well, it looks like the folks at Chassis Imports have been in the same situation and they’re here to help. Their new product is called the Slate Cleaner and it retails for $49.99 but the payoff is priceless. The painstaking task of using a filament brush and solder gun may finally be obsolete. In a development that seems too good and too simple to be true, the Slate Cleaner does all of the cleaning and turbinizing that once took two tools and an entire weekend.

Some may ask, “Okay, but how am I supposed to cross my valve planks while the shift resistor is cleaning and turbinizing at the same time?” Believe me, I asked that same question before I got my own hands on the Slate Cleaner. The answer lies in the second feature of this great new piece of equipment and it’s as simple as a ½ inch slit at the bottom of each side of your pipe fitter. Who knew that just a little cut could make such a big difference?

The folks at Chassis Imports have outdone themselves yet again. This could be the biggest development the industry has seen since the development of the Electric Ball-Bearing Motor. After a weekend of working with the Slate Cleaner from Chassis Imports you’ll agree with me that the Slate Cleaner will leave you working with a clean slate the next time you try to flush out a shift resistor.

No comments:

Post a Comment